Door Reversal Guide.pdf

To reverse a round door with electrical wiring, follow these steps:
1. Disconnect wiring from the door by removing the middle screw in the hinge and tucking the wiring into the opening.
2. Remove the door from the dryer by taking out the four screws securing the door hinge.
3. Move the door strike by rotating it 180° and attaching it to the opposite side of the dryer door frame.
4. Remove the inner door from the outer door by taking out the 10 screws securing it.
5. Remove the hinge by taking out the six screws holding the hinge assembly in place.
6. Remove the latch by flipping and rotating the inner door 180° and taking out the four screws securing the latch plate.
7. Reinstall the latch on the opposite side using the four screws removed earlier.
8. Reinstall the hinge assembly on the opposite side by flipping over the inner door and using a T20 screwdriver.
9. Remove the rotating assembly by lifting off the inner door assembly and taking out the two screws securing it.
10. Reposition the rotating assembly and tubing 180° to the opposite side of the door.
11. Rotate the assembly bottom and fasten it using the two screws removed earlier.
12. Reinstall the inner door assembly by positioning the door with the inside facing up and using a Phillips screwdriver to secure the 10 screws.
13. Reinstall the door on the dryer by pulling the wire through the front panel opening and securing it with the four T25 screws.
14. Reconnect the wiring by plugging in the wire and securing the rotating assembly to the hinge with the screw removed earlier.