EchoStream® EN1233S/D And EN1235S/D Pendant Transmitter Installation Instructions.pdf

# EchoStream® EN1233S/D and EN1235S/D Pendant Transmitter Installation Instructions

## Overview
- Contact Inovonics Wireless technical services for assistance:
- E-mail: [email protected]
- Phone: (800) 782-2709
- The pendant transmitter includes a battery, a Reset button, and frequency band selection pins.

## Components
Figure 1: Pendant Transmitter components include:
- Battery compartment
- Reset button
- Frequency band selection jumper

## Installation and Startup
### Install/Replace the Battery
1. Pry open the housing at both ends.
2. Remove the old battery if replacing.
3. Insert a new battery.
4. Press the Reset button to initialize.

### Select the Frequency Band
1. Pry open the housing.
2. Place the selection jumper on the appropriate pins:
- Off for 902-928 MHz (North America)
- Bottom pins marked NZ for 921-928 MHz (New Zealand)
- Top two pins marked AU for 915-928 MHz (Australia)
3. Press Reset to complete configuration.
Caution: Avoid touching frequency band selection pins while pressing Reset.

### Register the Pendant Transmitter
- Each pendant has a unique ID.
- Reset the transmitter as prompted by the receiver, then replace the cover.
- Test the pendant after registration by activating conditions and verifying responses.

## Operation
### Using the EN1233 Pendant Chain
- Always use the provided chain; substituting stronger cords may cause injury.

### Converting the Pendant Transmitter Belt Clip
- Secure the bottom of the belt clip to the housing with a coarse thread screw for a belt loop.
Figure 2: Use a coarse thread screw to secure the belt clip.

### Activating the Pendant Transmitter
- Press the button(s) for at least one second for single or double button transmitters.
- Alarm signals are transmitted and indicated by the blinking transmission LED.
- Release buttons to send an alarm restoration signal.

## Specifications
- Typical battery life: 3-5 years
- Battery type: Panasonic CR2 or equivalent
- Operating environment: 0-60°C (32-140°F), noncondensing

## Television and Radio Interference
- This device complies with FCC Part 15 and Industry Canada RSS standards.
- Follow measures to reduce interference if it occurs, such as reorienting antennas or separating equipment.

## FCC Part 15 and Industry Canada Compliance
- The device complies with applicable regulations.
- Operation subject to two conditions: no interference and acceptance of any received interference.

## Warranty and Disclaimer
- Inovonics warrants products for 36 months against defects in materials and workmanship.
- Warranty void for improper installation, misuse, alteration, accident, or tampering.
- Inovonics is not liable for incidental, consequential, or special damages.
- This warranty does not extend to products of other manufacturers used with Inovonics products.