FSP Locker Installation Safety And Guidance: Fire, Ventilation, Access, And More.pdf

Safety and Structural Considerations

This guide outlines critical safety precautions for installing FSP locker banks, ensuring compliance with essential design principles.

## Do's and Don'ts:

Do:
- Ensure clear egress paths, unobstructed pedestrian flow, and access to service areas.
- Allow adequate ventilation around lockers, especially in external or non-lockable environments.
- Maintain a 4-meter distance between locker banks and flammable materials to prevent fire spread.
- Lock individual locker doors overnight for safety against arson.
- Store lockers within secure, lockable areas when unattended or after hours.

Don't:
- Block or impede doorways, lifts, stairwells, passageways, or drainage grates.
- Cover or obstruct service access areas, electrical sub-boards, or fire safety equipment.
- Install over manholes or hinder the suitable extension of fire hoses.

## Installation Steps:

1. Positioning: Place the locker on top of the kicker base (if applicable). Ensure proper alignment by keeping the kicker base flush with the locker's back.

2. Drill Guide Holes: Drill 4x5mm holes through the locker, using the drilled holes as a guide to secure the kicker base with screws.

3. Secure Kicker Base: Fasten the kicker base firmly with screws.

4. Install Sloping Top:
- Position the sloping top on top of the locker.
- Drill 4x5mm guide holes and use 10-12 x 20mm hex screws to secure it.
- Ensure the sloping top is flush with the locker's back and evenly overhangs both sides.