Installation Guide.pdf

7" (229mm) from finishing edge to side wall
- B: 65" (1651mm) minimum clearance to enclosure ceiling
- C: varies by mantel height (see chart)
- D: 0" (0mm) from front of door to edge of floor protection
- E: 50" (1270mm) minimum alcove width

Fireplace Dimensions:
- Depth: 20” (508mm)
- Width: 45” (1143mm)
- Header Height: 38” (965mm)
- Enclosure Ceiling: 65” (1651mm)

Minimum Framing Dimensions:
- Vent size: 5/8
- Height: 65” (1651mm)
- Depth: 20” (508mm)
- Width: 38” (965mm)
- Header: 55” (1397mm)

Mantel Projections:
- Measured from bottom of fireplace
- Subtract 15 inches (381mm) to reference from tiling edge
- Combustible mantel can be installed over non-combustible board

Minimum Venting Requirements:
- Minimum venting shown in figure 20
- 12” vertical section and 90-degree elbow
- 1” (25mm) clearance on all sides of vertical vent pipe
- 1/4” rise for every 12” of horizontal run

Cool Surface System (CSS) Dimensions:
- Front Vent: various dimensions (see figure 4)
- Side Vent: various dimensions (see figure 5)
- Outlet minimum top and bottom standoff: 2 5/8” (6.7cm)

Revised Mantel Requirements:
- Minimum height of mantle: 31” (if using a surround)

Venting Clearances:
- Front Vent: minimum ceiling clearance from top of CSS outlet: 4” (10.2cm)
- Side Vent: minimum height to ceiling: 15.00” (38cm)
- CSS Horizontal Vent: minimum framing and clearances (see chart)
- CSS Vertical Vent: minimum framing and clearances (see chart)