Propane Gas Conversion And Installation Instructions For Range.pdf

This range is initially set for use with natural gas, but conversion to propane gas requires professional installation by a qualified propane gas installer. The conversion process involves specific orifices and instructions located on the back of the range, which should be retained for future reference if a switch back to natural gas is desired.

Dimensions and Clearances:
- Maintain adequate clearances between the range and combustible surfaces. Minimum clearances are: 30" (76.2 cm) from burners to unprotected wood or metal cabinets, or 24" (61 cm) with protection by 1/4" (6.4 mm) thick flame-retardant millboard covered with specified materials.
- For island installations, ensure a 2-1/2" clearance from the cutout to the back edge of the countertop and a 3" clearance from the cutout to the side edges.

Connector Hookup:

Tools Required:
- Flat-blade screwdriver
- Pipe wrenches (two, one for backup)
- Phillips screwdriver
- Open-end or adjustable wrench
- Pencil and ruler
- Level
- Drill, awl, or nail
- Pressure regulator

Materials Required:
- Gas line shut-off valve
- Pipe joint sealant or UL-approved pipe thread tape with Teflon*
- Flexible metal appliance connector (5 feet recommended)
- Flare union adapter for gas supply line (3/4" or 1/2" NPT x 1/2" I.D.)
- Flare union adapter for pressure regulator on range (1/2" NPT x 1/2" I.D.)
- Liquid leak detector or soapy water solution

Installation Steps:

1. Inform the consumer of the gas shut-off valve location.
2. Remove all packing material and literature from the oven before connecting gas and electrical supply.
3. Check with builder or cabinet supplier about cabinet materials' suitability to avoid discoloration, delamination, or damage.
4. Secure range to floor during transit if installed in a mobile home (conforming to relevant standards).

Important Warnings:
- Fire/Explosion Hazard: Improper installation can lead to fires, explosions, property damage, personal injury, or death. Only qualified installers should perform the conversion.
- Leak Testing: Conduct leak testing according to manufacturer instructions.
- Electrical Grounding: Ensure electrical grounding in accordance with local codes or, if absent, the National Electrical Code (ANSI/NFPA 70). In Canada, follow CSA C22.1 Canadian Electrical Code Part 1 and/or local codes.
- Avoid Air Curtain Hoods: Do not install this product with an air curtain hood that operates by blowing air down on the cooktop, as it may interfere with gas burner operation.