Uživatelský Manuál (133.7 KB).pdf

1. Carry out all manipulations with the lamp only when the power supply is disconnected from the mains.
2. Cut a hole according to the dimensions below.
3. Connect the 230V wires to the terminals of the power supply.
4. Connect the output connector on the power source to the LED panel.
5. Insert the fixture into the mounting hole.

General instructions and important safety information:
Please read this manual carefully before using the product and keep it for future reference.
For damage caused by improper use or changes in the product structure, LED Solution s.r.o. bears no responsibility.
Before handling the product in any way, make sure that the power supply is switched off.
All activities performed on electrical equipment must only be performed by a person with electrical technical qualifications.
The product is intended for use in an indoor and dry environment IP20.
The light source of this lamp is non-replaceable, after the end of the life of the lamp or damage to the cover, the entire lamp must be replaced.
When assembling, use only the parts that are included in the delivery.
Moistened cotton is best for cleaning the lamp. Do not use solvents, thinners or alcohol for cleaning.
When a fault is detected, disconnect the power supply from the socket or turn off the relevant circuit breaker, secure the body and the lamp until the fault is professionally repaired
do not use.
ATTENTION: Do not look directly into the light beam of the LED(s).